Using a terminal server is the typical way to connect the console ports of cluster components. However, it is possible to connect a terminal or terminal emulator directly to console ports when you cannot use or access a terminal server. May 27, 2016 E-Series ESM Serial Port Does anyone know if you can use the serial port on an E-series expansion to run commands like show serial to display the serial number and machine info? I don't have access to a controller unit at the moment. The console ports enable you to manage the server when a network connection is not available, for example, during software installation or network troubleshooting. About this task You can connect the storage controller console ports to a physical terminal or to a terminal or console server. New Netapp Controller have Baud Rate as 115200. The old system had the Baud Rate as 9600. Attached is my secure CRT connection settings. Automatic proxy configuration script (PAC) connection - script location is shown; A table that lists, for each storage array, the name of the array, whether or not it is an ASUP-capable array, the chassis serial numbers, and the IP addresses for the controllers in the array.
Active1 year, 7 months ago
I am attempting to enable web-management functionality on my Dell PowerConnect2824.
From what I can tell by reading the manual I need to connect via the serial port to enable web functionality.
I picked up a serial-to-USB adaptor and installed the drivers onto my Windows 7 machine. It now shows up in my Device Manager under Ports, Prolific USB-to-Serial Comm Port (COM5).
Usb To Serial Connection
However when I fire up PuTTY and choose 'serial' and enter COM5 the resulting terminal window simply hangs.
The PowerConnect uses VT100 protocol which from what I understand PuTTY recognizes. My serial settings are as follows:
2,17644 gold badges2222 silver badges2424 bronze badges
user30875user30875
4 Answers
Most switches that I have worked with do not use any flow control, so I double checked the Dell PowerConnect and it indeed does not use flow control.
From page 33 of the manual:9600 baud 8 data bits, 1 stop bit, and no paritySet flow control to noneUnder Properties, select VT100 for Emulation mode
jftugajftuga
4,86722 gold badges3131 silver badges4848 bronze badges
Try pressing Enter after connecting. As far as I know, there's no way for the device to know when PuTTY opens the serial port; an Enter keypress would serve as a 'attention' message and you should receive a reply.
Rs232 Serial Connection
grawitygrawity
This sounds stupid, but did you make sure that your serial to USB cable is also a null-modem cable?
I've had the same issue, until I figured out that I had to get a small null-modem bridge in order to actually communicate with a server with a serial console.
Christian ParedesChristian Paredes
What Is A Serial Connection
You probably need to read the switch's manual to see what serial options need to be set for Flow Control, Parity, etc. It should be in there somewhere.
MDMarraMDMarra
Netapp Serial Connection Settings Free
93.6k2929 gold badges181181 silver badges316316 bronze badges
Not the answer you're looking for? Browse other questions tagged puttyserial or ask your own question.
Configure Serial connection in your console application (PuTTY, HyperTerminal, SecureCRT, Minicom, etc).
Note: Refer to the Getting Started Guide for the relevant appliance (see sk96246).
Serial Connection CableComments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |